FRIZZLIFE INC.
www.frizzlife.com
Page 4
STEP 1： CONNECT THE 3 WAY FEED WATER
Pass the tubing
through the nut
Push and squeeze
the tubing to the very end
use a wrench
to tighten
: When using the wrench to tighten, be sure
not too looseor too tight in case of breaking the tubing.
WARNING
STEP 2： CONNECT THE WATER SUPPLY
STEP 3： CONNECT THE FILTER SYSTEM
Install with the
cold water supply
Shut off the water supply Remove the flexible hose
Connect the adapter and make sure
the rubber O ring is loaded
Connect the flexible hose Valve installation complete
Remove the small blue clip on the "SUPPLY" end and connect the 1/4" blue tube,
make sure the tubing hits the bottom of the fitting;
Lock back the blue clip;
Connect the"FILTERED" end with another blue tubing the same way.
1
2
3
Model: MP99
5. INSTALLATION STEPS
To Next Page
Loading...
