FRIZZLIFE INC.
www.frizzlife.com
Page 7
NOTE
IN CASE SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AND IMPLIED
WARRANTY LASTS, YOU MAY CHOOSE TO RETURN THE SYSTEM. IF YOU CHOOSE
TO KEEP IT, YOU AGREE THAT THE ABOVE LIMITATIONS STILL APPLY TO YOU.
Frizzlife is not liable for anything that we deem as abuse of the units, including but not
limited to, misuse of product outside of intended use, equipment modifications,
unauthorized repairs, improper installation, damage from freezing, hot water,
fire or other acts of God outside of Frizzlife control.
As a condition of this Limited Warranty, the owner must ensure that periodic maintenance
of the system is performed as described in the literature enclosed with the system. Should
your unit develop a defect or otherwise fail to perform in accordance with this warranty,
you should contact the retailer from whom the product was originally purchased.
Filter Cartridges are considered as disposable items, thus are not covered by warranty.
Incoming water to the the system cannot exceed 100°F.
This warranty will be void if defects occur due to failure to observe the following
conditions:
1. Email us your order ID and full name at support@frizzlife.com
2. Scan the QR code below to register
Owner’ s Warranty Responsibility:
150% Extended Warranty
1.
2.
Customer is responsible for proper operation, which includes complete and continual
leak inspection.
3.
Do not use outdoors or in a location that is subjected to direct sunlight or freezing.
This warranty will not be effective unless and until the Frizzlife is shown to have
been used in accordance with the installation and maintenance instructions
accompanying the product.
Most of the unit components are made of plastic and eventually can break
or crack from stress.
There are no other warranties which extend beyond what is described above.
To receive warranty service, please contact Frizzlife at support@frizzlife.com
Model: MP99
The filter cartridges should be replaced in time according to the recommended
replacement period.
The plastic housings should be replaced every 18 months.
To Previous Page
Loading...
