FROG Leap Twin - Maintenance - Replacing Control Dial O-Rings; Maintenance - Replacing Cap O-Rings and Knobs

22
1.
2.
3.
4.
5.
2.
1.
4.
3.
5.
FROG Leap Twin Infuzers Maintenance
Replacing the Control Dial O-Rings
In the back of the FROG Leap
Twin Infuzers depress center of
locking pin with a nger and pull
pin out of dial.
Center of locking pin
Turn control dial back and forth
as you pull it out of the housing.
Replace both O-rings. Apply
silicone lubricant that came with
your FROG Leap Twin Infuzers on
O-rings.
Carefully insert control dial
back into housing.
Replace locking pin by pushing it
through the slots on the dial until
it locks into place.
Replacing Cap O-Ring
Lubricate O-ring every couple
of months with silicone
lubricant that came with your
FROG Leap Twin Infuzers.
DO NOT USE petroleum based
lubricants.
Replacing Knobs
To replace, simply unscrew old knob and replace with the
new one.
Front of Infuzers
Back of Infuzers
Place new O-ring in bottom
half of groove.
Place your thumbs on each
side of the cap over the O-ring
in the groove.
Roll your thumbs back and
forth over the O-ring while
pushing upward until the
O-ring falls into the top of the
groove.
Top half of
groove
O-ring in top
of groove
Bottom half
of groove
Product # 01-22-9970
Product # 01-22-9970
Remove old O-ring.