02/2017 2/17
1. GENERAL
Fronius Smart Meters are energy meters which can be used to measure
consumption data of a site, or for export limitation of a PV system with the
Fronius SnapINverter range.
The Fronius Smart Meter measures the power flow to the loads, or grid,
and feeds the information via ModBus RTU/ RS485 communication to the
Fronius Datamanager 2.0 (comes built-in with Fronius Galvo, Primo, Symo
and Eco SnapINverters, excluding Light versions. It can also be retrofitted
to all other Fronius inverters).
This document describes how to install and set up only the 63A-1 single phase or 63A-3 3-phase
Fronius Smart Meters. Please use the below links if using a different model of Fronius Smart Meter.
Further information about the entire range of Fronius Smart Meters can be found in our Fronius Smart Meter
Application Guide:
https://www.fronius.com/~/downloads/Solar%20Energy/Whitepaper/SE_WP_Fronius_Smart_Meter_Application
_Guide_EN_AU.pdf
For installation and setup instructions of the 240V1-UL or 480V3-UL Fronius Smart Meters refer to the following
document:
https://www.fronius.com/~/downloads/Solar%20Energy/Operating%20Instructions/42%2C0410%2C2289.pdf
For installation and setup instructions of the 50kA-3 Fronius Smart Meter refer to the following document:
https://www.fronius.com/~/downloads/Solar%20Energy/Technical%20Articles/SE_TEA_Quick_Guide_How_to_i
nstall_and_commission_a_Fronius_Smart_Meter_50kA-3_EN_AU.pdf
The document for setting export limitation with the Fronius Smart Meter can be found here:
https://www.fronius.com/~/downloads/Solar%20Energy/Technical%20Articles/SE_TEA_Quick_Guide_How_to_
set_up_Export_Limiting_using_the_Fronius_Smart_Meter_EN_AU.pdf
To Next Page
Loading...
Need help?
General
