To Next PageTo Next Page
Need help?Do you have a question about the Fronius 63A-3 and is the answer not in the manual?
General| Brand | Fronius |
|---|---|
| Model | 63A-3 |
| Category | Measuring Instruments |
| Language | English |
Explains the meaning of DANGER!, WARNING!, CAUTION!, and NOTE! symbols used in the document.
Covers device safety, personnel qualifications, and handling safety notices.
Describes the Fronius Smart Meter as a bidirectional electricity meter for optimizing self-consumption.
Explains symbols on the rating plate and possible installation locations.
A numbered list of steps and cross-references for installing the Fronius Smart Meter.
Details physical mounting on a DIN rail and requirements for protective circuits.
Warns about mains voltage and provides cable connection specifications.
Details connecting the data communication cable for Fronius SnapInverter.
Explains symbols used for inverters, meters, and Modbus RTU slaves.
Illustrates recommended setups for terminating resistors.
Illustrates recommended setups for terminating resistors.
Explains symbols for Grid, Inverter, and Utility meter.
Describes Primary, Secondary, Producer meters, Modbus RTU slaves, and system loads.
Explains maximum Modbus participants for SnapInverter and device limitations.
Table showing Modbus participant combinations for SnapInverter.
Explains setting addresses for multiple meters and using terminating resistors.
Table showing Modbus participant combinations for GEN24 inverter.
Describes a graphic view of the menu structure provided in user information.
Details steps for navigating menus to set the Smart Meter address.
Important notes for trained personnel and service password for meter settings.
Provides step-by-step instructions for connecting via Access Point and LAN.
Details steps to configure the Smart Meter as the primary meter via web browser.
Important notes for trained personnel and technician password for device configuration.
Instructions for WLAN and Ethernet installation using the web browser.
Lists technical specifications for the input of the Fronius Smart Meter.
Lists technical specifications for the output, including energy pulse and RS485.
Details output response time, insulation, and electromagnetic compatibility.
Lists operating conditions, temperature limits, and housing specifications.
Specifies wire sizes and torque for input and output screw terminals.
