(c) Fronius Australia Pty. Ltd, 2015 7/10
2 INSTALLATION AND SETUP OF THE FRONIUS SMART METER
2.1 Schematics and Wiring
Diagram 3 shows the system configuration
(Diagram 3)
Please note:
/ Wiring between meter and inverter should use CAT5 or CAT6 cable (LAN cable)
/ Connection is a data line for Modbus RTU / RS485 using screw terminals on the meter
/ Maximum distance: 300 m (980 feet)
Meter connection on the Datamanager V2
The meter needs to be connected to the Datamanager’s binary output, as shown in diagram 4.
(Diagram 4)
Fronius inverter with
Datamanager V2
To Next Page
Loading...
