To Next PageTo Next PageWhat to do if Fronius Acctiva Professional Automobile Battery Charger terminals connected to wrong poles?
If you've connected the charging terminals of your Fronius Automobile Battery Charger to the wrong poles, simply swap the charging terminals around to correct the polarity.
What to do if consumer load connected to battery of Fronius Automobile Battery Charger?
If there's a consumer load connected to the battery while using the Fronius Automobile Battery Charger, switch off the consumer or select standard charging mode.
General| Input Voltage | 230 V |
|---|---|
| Input Frequency | 50-60 Hz |
| Battery Voltage | 12 V / 24 V |
| Battery Types | Lead-acid, AGM, GEL |
| Protection Features | Reverse polarity, Overload, Short circuit |
Indicates a possibly dangerous situation where death or serious injury may result if not avoided.
Indicates a situation where damage or injury could occur if not avoided, resulting in minor injury or property damage.
Indicates a risk of flawed results and possible damage to the equipment.
The charger must be used exclusively for its intended purpose, including following instructions and performing maintenance.
Warns about electrocution risks and hazardous electromagnetic fields, advising safety precautions.
Batteries contain harmful acid and release explosive gases; use in ventilated areas and maintain distance from ignition sources.
Keep persons, especially children, out of the working area and warn them about dangers.
Chargers with PE conductors require a grounded mains supply; use only according to protection class.
Ensure cooling air flow, check PE conductors, repair faulty safety devices, and use an accessible mains plug.
Operator must arrange safety inspections at least every 12 months by a qualified electrician.
Manual charging procedure for batteries with voltage below 2V, including warnings about terminal connection.
Lists common error codes, their causes (e.g., wrong polarity, overheating, general fault), and remedies.
