Fronius OPT/i WF R Installation Instructions

22
Operation of the
"Delay" switch
The sensor outputs a signal when it detects
the end of the wire. If the sensor then de-
tects the wire electrode again, the signal re-
mains on for a short period. The amount of
time the signal remains on depends on the
setting of the "Delay" switch:
- "Off" = normal signal duration
- "On" = signal duration extended by 10
ms (factory setting)
ON OFF
DELAY

Fronius OPT/i WF R Specifications

General

Brand	Fronius
Model	OPT/i WF R
Category	Accessories
Language	English