Fronius Robacta PTW 1500 - Assembling the Robacta PTW 500, 1500, 3500; Safety

Assembling the Robacta PTW 500, 1500, 3500
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this device
and all system components.
Assembling the
Robacta PTW
500
1
2
3
5
4
Insert clamping sleeve
1
2x360°
3
1
3
2
Insert tungsten electrode
2
IMPORTANT! Insert the tungsten electrode so that the tip protrudes approx. 10
mm out of the torch body. Slightly tighten the torch cap so that the tungsten
electrode can still move inside the torch body.
3
2
1
Assemble centring tube, plasma nozzle and
shielding gas nozzle
3
IMPORTANT! Check that the tungsten
electrode is adjusted correctly (see
„Adjusting the tungsten electrode.
28