Fronius Robacta PTW 1500 - PTW 500 Options; PTW 1500 Options; PTW 3500 Options

Assembling the
Robacta PTW
1500
1
2
3
4
Fit holder, insert clamping sleeve
1
2
1
Insert tungsten electrode
2
IMPORTANT! Insert the tungsten electrode so that the tip protrudes approx. 10
mm out of the torch body. Slightly tighten the torch cap so that the tungsten
electrode can still move inside the torch body.
10 mm
max. 3 Nm
2
3
1
Assemble centring tube, plasma nozzle and
shielding gas nozzle
3
IMPORTANT! Check that the tungsten
electrode is adjusted correctly (see
„Adjusting the tungsten electrode“)
29
EN