28
SETUP menu item
Initial setting The inverter is pre-configured and ready to use. There is no need to enter any initial set-
tings before using it to feed energy into the grid, as this is a fully-automated process.
The SETUP menu item allows the initial settings of the inverter to be changed easily to
bring it in line, as closely as possible, with the preferences and requirements of the user.
Software updates
Navigating in the
SETUP menu item
NOTE! As a result of software updates, you may find that your device has certain
functions that are not described in these operating instructions, or vice versa. Cer-
tain illustrations may also differ slightly from the actual controls on your device,
but these controls function in exactly the same way.
Enter the SETUP menu item
In the menu level, use the 'Left' or
'Right' keys to select the 'SETUP'
menu item
Press 'Enter'
The first entry under the SETUP menu
item is displayed:
'Standby'
Scrolling between the entries
Use the 'Up' and 'Down' keys to move
between the available entries
Exiting an entry
To exit a menu entry, press the 'Back'
key
The menu level appears
GRAPH
1
2
Relay
Relay
3
GRAPH
4
To Next Page
Loading...
Need help?
General