Need help?Do you have a question about the Fronius VARIOSTAR 357-2 and is the answer not in the manual?
General| Input Voltage | 400 V |
|---|---|
| Output Current | 350 A |
| Weight | 50 kg |
| Welding Process | MIG/MAG, TIG, MMA |
| Mains Voltage | 3 x 400 V |
| Mains Frequency | 50/60 Hz |
| Protection Class | IP23 |
| Insulation Class | F |
| Input Frequency | 50/60 Hz |
| Efficiency | 85 % |
| Power Factor | 0.93 |
| Duty Cycle | 60 % |
Details risks from gases, sparks, electrical current, and dangerous spots.
Essential protective gear, installation safety, and precautions.
Precautions in normal operation and safety inspection requirements.
Guidelines on intended use, machine setup, and protection.
Instructions for connecting the welding machine to the power supply.
Attaching the FK 57 cooling unit to the VST 357-2/457-2 models.
Safe procedures for setting up and connecting a gas cylinder.
How to properly connect the welding torch to the machine.
Step-by-step guide for feeding the welding wire into the machine.
Explains diagnostic codes and their potential causes and remedies.
Lists common faults, their causes, and recommended solutions.
To Next Page