Need help?Do you have a question about the Fronius VR 7000 CMT and is the answer not in the manual?
General| Input Voltage | 3 x 400 V |
|---|---|
| Protection Class | IP23 |
| Welding Process | MIG/MAG, MMA |
| Input Frequency | 50-60 Hz |
| Output Current Range | 5 - 160 A |
General safety regulations, proper use, and environmental conditions.
Protecting personnel, noise, toxic gases, sparks, electrical risks, and EMF.
Safety during installation, transport, operation, maintenance, and disposal.
Overview of the VR 7000 wirefeeder, its features, and application areas.
Compatible power sources and welding processes for the wirefeeders.
Explanation of safety symbols and warning notices on the device.
Details on optional control panels, mode switches, and installation kits.
Description of the standard control panel, indicators, and parameter adjustment.
Identification of connectors and components on the wirefeeder's front, rear, and sides.
Procedures for placing, connecting wirefeeders to power sources and welding torches.
Instructions for inserting and replacing feed rollers and wire spools.
Steps for feeding wire, setting contact pressure, and adjusting the brake.
Purpose, types, and fitting procedure for wirefeeding hoses.
Requirements for start-up, care, and regular maintenance tasks.
Detailed technical data for VR 7000, VR 7000-11, VR 7000-30, and VR 7000 CMT.
Spare parts list and diagrams for motorplates and connectors.
To Next Page