Fronius WF 25i Case D200 - WF 25 i Case D300 Controls and Connections

Optional control panels
Safety
WARNING!
Danger from incorrect operation.
This can result in severe personal injury and damage to property.
▶
All the functions described may only be used by trained and qualified personnel.
▶
Fully read and understand this document.
▶
Fully read and understand all the Operating Instructions for the system components,
especially the safety rules.
General
NOTE!
Optional control panels are available for the WF 25i Case D200 and WF 25i Case
D300 wire-feed units.
The design and position of the control panels are identical for both wire-feed units.
OPT/i WF POT
control panel
(3)
(1)
(2)
No. Function
(1) OPT/i WF POT control panel
(2) - Setting the welding power
(during MIG/MAG synergic
welding - Standard, Puls, PMC,
LSC)
- Setting the wire feed speed
(during MIG/MAG standard
manual welding)
No. Function
(3) - Correcting the arc length
(during MIG/MAG synergic welding - Standard, Puls, PMC, LSC)
- = shorter arc length
0 = neutral arc length
+ = longer arc length
- Setting the welding voltage
(during MIG/MAG standard manual welding)
29
EN