Fronius WF 25i Case D200 - Wire Electrode Threading and Brake Adjustment

Adjust the brake
General
CAUTION!
Risk of injury and material damage from the welding current and accidental igni-
tion of an arc.
Before starting work, disconnect the ground earth connection between the welding sys-
tem and the workpiece.
CAUTION!
Risk of injury and damage from wire electrode emerging.
While working:
▶
hold the welding torch with the point directed away from the face and body
▶
wear suitable protective goggles
▶
do not point the welding torch at people
▶
make sure that the wire electrode does not touch any conductive or earthed parts,
such as the housing, etc.
NOTE!
After releasing the torch trigger the wirespool must stop unreeling.
If it continues unreeling, readjust the brake.
Setting the brake:
D200 device
1
4
5
STOP
6
7
3
1
2
1 2
48