Connecting the interconnecting hosepack and
MIG/MAG welding torches
Safety
WARNING!
Danger from electric current.
This can result in severe personal injury and damage to property.
▶
Turn the power source mains switch to the "O" position.
▶
Disconnect the power source from the mains.
▶
Ensure that the power source remains disconnected from the mains until all work
has been completed.
General informa-
tion
The wire-feed unit is connected to the power source using the interconnecting hosepack.
Connecting the
interconnecting
hosepack
CAUTION!
Risk of injury and damage from loose connections.
All cables, lines and hosepacks must be properly secured, undamaged, insulated and
adequately dimensioned at all times.
1
* Only if the coolant connections are
fitted in the wirefeeder and when
using a water-cooled welding torch
2
40
To Next Page
Loading...
