Fronius WF 25i - Optional Control Panel Functions

26
Optional control panels
Safety
WARNING!
Danger from incorrect operation.
This can result in severe personal injury and damage to property.
► All the functions described may only be used by trained and qualified personnel.
► Fully read and understand this document.
► Fully read and understand all the Operating Instructions for the system components,
especially the safety rules.
OPT/i WF POT
control panel
The adjusters perform different functi-
ons depending on the application.
(2)(1)
No. Adjuster function during MIG/MAG welding
(the remote control performs different functions depending on the welding
process)
(1) - Setting the welding power
(during MIG/MAG synergic welding - Standard, Pulse, PMC, LSC)
- Setting the wire speed
(during MIG/MAG standard manual welding)
(2) - Correcting the arc length
(during MIG/MAG synergic welding - Standard, Pulse, PMC, LSC)
- = shorter arc length
0 = neutral arc length
+ = longer arc length
- Setting the welding voltage
(during MIG/MAG standard manual welding)
No. Adjuster functions during electrode welding
(1) Setting the welding current
(2) Influencing the arc-force dynamic:
- 0 = soft, low-spatter arc
- 10 = harder, more stable arc