Storage
At the end of the season and when putting the disc into storage:
□ Clean dirt and debris from around moving parts and from the top of the frame, gang bars, hitch
and bridle.
□ Pay special attention to cleaning the area around the bearings. Spray a light coating of oil or
rust preventative around the seal area of the bearings.
□ Lubricate all grease fittings to prevent moisture infiltration.
□ It is recommended to park with the disk in the raised position, coat the exposed hydraulic
cylinder rod with grease, install the transport stay and relieve the hydraulic pressure. Place a
block under the hitch jack to prevent it from sinking into the ground and be sure the tires are
properly inflated. Chock the tires front and rear.
□ Clean disk blades to minimize rust.
□ Coat the quick disconnects in grease and wrap in plastic to prevent rust.
□ Make a final inspection for worn, damaged or missing parts and make necessary repairs
before the next season.
49
To Next Page
Loading...
Need help?
General
