Putting into service
29
DM1160
-
- Attach PTO shaft guard using chain provided in order
to prevent it from rotating.
Adjusting the machine
Positioning of lower links
- Measure dimension A.
- Adjust tractor lower link stabilizers to measure A =
50 mm (2’’).
Hitch pin parallelism.
From the headland turn position:
Measure and adjust the height of the hitch pins until the
same measure is obtained on each side:
- Note the difference in height between the two hitch
pins.
- Place the machine in working position:
- Adjust the tractor left levelling rod according to the
difference in height.
- Place the machine in headland turn position.
- Check the difference in height between the 2 hitch
pins.
- Proceed the same way to obtain identical (A) and (B)
heights.
Immediately replace any worn or damaged
guard.
A
To Next Page
Loading...
