Instructions for work
39
DM1160
2. Adjustments in working position
Cutting height
The desired cutting height is obtained directly by
adjusting the top link length. The height can be adjusted
between 30 and 80 mm (1.1’’ - 3.1’’) depending on the
tractors.
To obtain a different cutting height:
- Place the machine in working position.
- Lower the machine on the ground to remove weight
from the top link.
- Modify the top link length to alter the machine tilt
angle.
- Place the machine in working position to check cutting
height.
-
Too low a cutting height can lead to:
Excessive disk and knife wear.
Crop being contaminated by soil.
Delay in regrowth.
To Next Page
Loading...
