56
Maintenance and storage
DM1160
Checking cutterbar oil level
Regularly check the cutterbar oil level:
From the transport position:
• Remove filler plug (1).
• The oil must reach the lower edge of the filling hole.
• Top up if necessary.
• Clean and reinstall filler plug (1) and its
washer. (Replace if necessary).
If it is found that the transmission case is very hot
to touch by hand, there is no cause of alarm
provided:
- Lubrication recommendations have been
respected.
- Disks can be rotated freely by hand when the
machine is hot.
Before checking that the disks rotate freely
by hand:
- Turn off the engine, remove ignition key
and wait until all moving parts have
come to a complete stop.
To Next Page
Loading...
