Frontier ST1129 User Manual (English)

Questions and Answers:

E
Elizabeth LopezAug 15, 2025
Why does my Frontier Snow Blower engine run erratically?
- K
  Karen HayesAug 15, 2025
  If your Frontier Snow Blower engine runs erratically, several factors could be the cause. A blocked fuel line could be the problem, so cleaning the fuel line is recommended. Another potential reason is an empty gas tank, in which case you should check the fuel supply. Stale gasoline may also cause this issue; try adding fresh gasoline with a fuel stabilizer. Lastly, water or dirt in the fuel system can lead to erratic engine performance. Remove the carburetor bowl to drain the fuel tank and refill it with fresh fuel. Remember, do not remove the carburetor bowl when the engine is hot.
A
Andrew WestAug 18, 2025
What to do if my Frontier ST1129 fails to discharge snow?
- B
  Bradley CastilloAug 18, 2025
  If your Frontier Snow Blower is not discharging snow, there might be several reasons. The auger drive belt could be loose or damaged, requiring replacement or adjustment. The auger control cable might not be adjusted correctly, so ensure it is properly adjusted. A broken shear bolt can also cause this issue, and it should be replaced. Additionally, the discharge chute could be clogged, so stop the engine immediately, disconnect the spark plug wire, and clean the discharge chute and the inside of the auger housing. Finally, a foreign object lodged in the auger can prevent snow discharge; stop the engine immediately, disconnect the spark plug wire, and remove the object from the auger.
I
ianblakeAug 21, 2025
What causes excessive vibration in my Frontier ST1129 Snow Blower?
- C
  Christopher HenryAug 22, 2025
  If your Frontier Snow Blower experiences excessive vibration, it could be due to loose parts or a damaged impeller. Stop the engine immediately, remove the spark plug wire, and tighten all bolts. Make any necessary repairs. If the vibration continues, have the unit serviced by a competent repairman.
S
Sara SmithAug 26, 2025
What to do if Frontier ST1129 Snow Blower loses power?
- V
  valdezjosephAug 26, 2025
  If your Frontier Snow Blower is losing power, the gas cap vent hole might be plugged. Remove any ice and snow from the cap, and make sure the vent hole is clear.
B
Bradley HunterAug 28, 2025
What to do if Frontier ST1129 Snow Blower fails to discharge snow?
- S
  scottmorrisonAug 28, 2025
  If your Frontier Snow Blower isn't discharging snow, it could be due to several reasons: * The auger drive belt might be loose or damaged. * The auger control cable might not be adjusted correctly. * A shear bolt might be broken. * The discharge chute could be clogged. * A foreign object might be lodged in the auger. To resolve this, you may need to replace or adjust the auger drive belt, adjust the auger control cable, replace the shear bolt, stop the engine immediately and disconnect the spark plug wire, then clean the discharge chute and inside of the auger housing, or stop the engine immediately and disconnect the spark plug wire, then remove any foreign object from the auger.
A
Adam JensenAug 31, 2025
What to do if my Frontier ST1129 has excessive vibration?
- L
  Lauren FitzgeraldSep 1, 2025
  If your Frontier Snow Blower is vibrating excessively, it could be due to loose parts or a damaged impeller. Immediately stop the engine and remove the spark plug wire. Then, tighten all bolts and make any necessary repairs. If the vibration continues, have the unit serviced by a competent repairman.
I
iaguilarSep 4, 2025
Why Frontier ST1129 unit fails to propel itself?
- A
  Aimee CainSep 4, 2025
  If your Frontier Snow Blower isn't moving, the drive belt might be loose or damaged, the traction drive cable might be incorrectly adjusted or the friction disc might be worn or damaged.
H
heidi89Sep 7, 2025
Why does my Frontier ST1129 engine stall?
- A
  Aaron CharlesSep 7, 2025
  If your Frontier Snow Blower engine stalls, it might be running on CHOKE. Set the choke lever to the RUN position.
D
Dylan DyerSep 10, 2025
How to fix difficult starting Frontier ST1129 Snow Blower?
- V
  Vanessa BishopSep 12, 2025
  If your Frontier Snow Blower is difficult to start, the spark plug might be defective. Replace the defective spark plug.