Frontier ST0927 - User Manual

Questions and Answers

K
Kimberly ParksAug 1, 2025
Why does my Frontier Snow Blower engine run erratically?
- J
  jameslambAug 1, 2025
  If your Frontier Snow Blower engine runs erratically, several factors could be the cause. A blocked fuel line could be the problem, so cleaning the fuel line is recommended. Another potential reason is an empty gas tank, in which case you should check the fuel supply. Stale gasoline may also cause this issue; try adding fresh gasoline with a fuel stabilizer. Lastly, water or dirt in the fuel system can lead to erratic engine performance. Remove the carburetor bowl to drain the fuel tank and refill it with fresh fuel. Remember, do not remove the carburetor bowl when the engine is hot.
B
Barbara NguyenAug 6, 2025
What to do if my Frontier ST0927 Snow Blower fails to discharge snow?
- M
  Maria PayneAug 6, 2025
  If your Frontier Snow Blower is not discharging snow, there might be several reasons. The auger drive belt could be loose or damaged, requiring replacement or adjustment. The auger control cable might not be adjusted correctly, so ensure it is properly adjusted. A broken shear bolt can also cause this issue, and it should be replaced. Additionally, the discharge chute could be clogged, so stop the engine immediately, disconnect the spark plug wire, and clean the discharge chute and the inside of the auger housing. Finally, a foreign object lodged in the auger can prevent snow discharge; stop the engine immediately, disconnect the spark plug wire, and remove the object from the auger.
R
Robert BarnesAug 11, 2025
Why does my Frontier ST0927 Snow Blower have a loss of power?
- S
  Stephanie MoraAug 11, 2025
  If your Frontier Snow Blower has loss of power, the gas cap vent hole might be plugged. Remove any ice and snow from the cap and ensure the vent hole is clear.
A
Ashley KellyAug 15, 2025
How to fix a Frontier Snow Blower that is difficult to start?
- H
  Heather ReedAug 16, 2025
  If your Frontier Snow Blower is difficult to start, the spark plug may be defective. Replacing the defective spark plug should resolve this issue.
S
Samuel GibsonAug 20, 2025
What to do if the engine stalls on my Frontier ST0927 Snow Blower?
- E
  Eric OrtegaAug 20, 2025
  If the engine of your Frontier Snow Blower stalls, it might be running on CHOKE. Set the choke lever to the RUN position.
D
Daniel FrenchAug 26, 2025
What causes excessive vibration in my Frontier ST0927 Snow Blower?
- S
  Sherri ParkerAug 26, 2025
  If your Frontier Snow Blower experiences excessive vibration, it could be due to loose parts or a damaged impeller. Stop the engine immediately, remove the spark plug wire, and tighten all bolts. Make any necessary repairs. If the vibration continues, have the unit serviced by a competent repairman.

Summary

INTRODUCTION

Owners Responsibilities

Outlines the owner's duties for safe operation, maintenance, and product knowledge.

RULES FOR SAFE OPERATION

Operating Symbols and Meanings

Explains the meaning of symbols used on the equipment for safe operation and hazard identification.

Hazard Symbols and Meanings

Identifies hazard symbols and their associated signal words to alert users to potential dangers.

OWNERS INFORMATION

Three Year Limited Warranty

Details the warranty coverage, terms, limitations, and claims process for the snowthrower and engine.

OPERATION

Engine and Snowthrower Controls Overview

Identifies and explains the function of all engine and snowthrower operating controls.

Snowthrower Operation Basics

Covers stopping the unit, controlling snow discharge direction, and moving forward/backward.

Starting and Stopping the Engine

Details procedures for starting, stopping, and cold-starting the engine via electric or recoil start.

Clearing Clogged Chutes and Frozen Starters

SERVICE RECOMMENDATIONS

Maintenance Schedule and After-Use Checks

MAINTENANCE

Auger Drive Belt Adjustment

Engine Oil Maintenance

Covers checking, changing, and draining the engine crankcase oil.

Auger Housing Height Adjustment

Belt Adjustment and Replacement Procedures

Cable Adjustment Procedures

Friction Wheel Maintenance

Auger Shear Bolt and Spark Plug Maintenance

STORAGE

Off-Season Storage Preparation

REPLACEMENT PARTS

SPECIFICATIONS ST0927

Frontier ST0927 Specifications

General

Drive Type	Wheel Drive
Number of Forward Speeds	6
Number of Reverse Speeds	2
Type	Two-Stage
Starting System	Recoil
Engine Type	4-Cycle
Throw Distance	Up to 40 ft. (12.2 m)
Starter Type	Recoil