Frontier SB1184 User Manual (English)

Questions and Answers:

R
Rebecca PooleAug 11, 2025
How to fix a cross kit issue on a Frontier Snow Blower?
- A
  Anthony DickersonAug 12, 2025
  If you're experiencing issues with the cross kit on your Frontier Snow Blower, start by ensuring you're using the appropriate safety device to prevent extreme torque peaks or shock loads. If axial loads are too high, consider changing to a larger driveline size. Carefully follow the greasing instructions to avoid inadequate greasing. Also verify compatibility between shaft and working conditions if you have excessive continuous torque and/or excessive working angle. Shorten the driveline shaft and replace defective cross bearings.
K
Kathy McclainAug 19, 2025
What to do if telescopic tubes are damaged on my Frontier Snow Blower?
- S
  Sean HolmesAug 19, 2025
  If you're having trouble with the telescopic tubes on your Frontier Snow Blower, make sure to use an appropriate safety device to protect against extreme torque peaks or shock loads. Consider changing to a larger driveline size if there's short tube engagement. If experiencing extreme load when sliding, switch to a driveline with a rilsan-coated inner tube. Replace the driveline drive shaft with one having adequate length and replace defective tubes. Ensure you carefully follow greasing instructions.
J
Jose RyanAug 27, 2025
Why is the yoke failing on my Frontier SB1184 Snow Blower?
- J
  Janet DunnAug 27, 2025
  If you're experiencing issues with the yoke on your Frontier Snow Blower, start by shortening the shaft length by cutting both telescopic tubes and shields, and removing any burrs if the shaft length is excessive. If axial loads are too high, replace the defective yokes. Clean and grease the telescopic tubes and replace both tubes if necessary, if you have excessive working angle and torque. Disengage the tractor driveline during cornering or when lifting or lowering the implement. Change to a larger driveline size. Engage the driveline more carefully to prevent overload caused by high starting and peak torques. Use appropriate safety devices and avoid excessive working angles.
T
Tina MarshallSep 3, 2025
How to troubleshoot the quick-disconnect yoke on a Frontier SB1184?
- Q
  qadamsSep 3, 2025
  To address issues with the quick-disconnect yoke on your Frontier Snow Blower, start by cleaning and oiling the quick-disconnect pin, following the service instructions if the pin is dirty due to insufficient maintenance. If the quick-disconnect pin is defective due to forced engagement or incorrect handling, replace it. If the shaft length is excessive, shorten it by cutting both telescopic tubes and the shield, and remove any burrs. If axial loads are too high, replace the quick-disconnect pin.