LUBRICATION GUIDE
GREASE FITTINGS
There are twelve grease fittings on the Carted Rake. If lubricated properly and often enough, it will prolong
the life of your Carted Rake. Grease daily during normal use and before and after storage and after
power washing. Use a good grade of high quality grease. Make sure that grease comes out around the
shaft on sleeve type bearings. Wipe off excessive grease to prevent accumulation of chaff or grit around
the bearing.
LOCATION
Listed and shown are the description of location and number of grease fittings.
A. (2) One on each end fo left side lift linkage
B. (2) One on each pivot arm pivot point
C. (4) Two on each of lifter arms
D. (2) One on each horizontal pivot point at the end of lifter arms
E. (2) One on each vertical pivot point, rake arm mount
F. (1) Center kicker wheel arm (If Equipped)
G. (4) One on each rake arm (6 on WR3010 & WR3012)
E
D
C
A
B
A
G
F
-16-
To Next Page
Loading...
