Installation and use
Ÿ Ensure that the structural anchor to which Electron Tie-Back SRL is to be attached, and on which work is to be performed, is free
of all hazards, including, but not limited to, debris, rot, rust, sharp or abrasive edges and surfaces, and hazardous materials.
Ÿ Wrap Tie- Back SRL lifeline around selected structural anchor, and attach snap hook on to webbing below shock pack (Never
attach snap hook between housing and shock pack). Attach Electron Tie-back karabiner to applicable harness D-ring.
WARNING:
If the Electron with rebar hook configuration is used, then the rebar hook should always be connected to the anchorage
structure, and NEVER to the dorsal D-ring of the full body harness. And the Electron casing should always be worn at the
harness end. A competent person must always ensure compatibility of the anchorage structure with the Electron.
5. GENERAL REQUIREMENTS, WARNINGS AND LIMITATIONS:
Ÿ The Equipment is designed for use as a part of a personal fall protection system. Components must not be used for any other
operation other than that which it has been designed and approved. Fall Arrest system are designed to comply with OSHA. Fall
Restraint System must be designed by a Qualified Person, and must be installed and used under the supervision of a competent
person.
Ÿ All authorized persons/users must refer the regulations governing occupational safety, as well as applicable ANSI or CSA
standards. Please refer to product labeling for information on specific OSHA regulations, ANSI and CSA standards met by
product.
Ÿ Proper precautions should always be taken to remove any obstructions, debris, material, or other recognized hazards from the
work area that could cause injuries or interfere the operations of the system. All equipment must be inspected before each use
according to the manufacturer's instructions. All equipment should be inspected by a qualified person on a regular basis.
Ÿ To minimize the potential for accidental disengagement, a competent person must ensure system compatibility.
Ÿ Equipment must not be altered in any way. Repairs must be performed only by the manufacturer, or persons or entities authorized
in writing by the manufacturer.
Shock Pack
Structural Anchor (I –beam)
Snap Hook
To this eye hole, attach
karabiner to applicable harness
5
3. HOW TO USE ELECTRON AS TIE-BACK: FRONTLINE Electron with Tie-back hook should be used with the SRL casing attached to the
Dorsal D-ring of the full body harness, and the extended webbing (with a sheath) wrapped around the anchorage structure, and the Tie-
back hook secured around the webbing.
WARNING:
Ÿ NEVER use Electron Tie Back SRL in Leading Edge (LE) applications.
Ÿ ALWAYS avoid lifeline contact with sharp or abrasive edges and surfaces.
Ÿ For Tie – Back application, snap hook must only be attached to webbing below shock pack. NEVER attach snap hook
between housing and shock pack.
Ÿ No Free Fall is allowed
To Next Page
Loading...
Need help?
General
