Considers when calculating distance:
Ÿ Distance of Deceleration
Ÿ Movement of harness attachment element (D-ring)
Ÿ Free Fall Distance
Ÿ Worker Height (Worker's height could affect the free fall distance)
Ÿ Elevation of Anchorage Connector
Ÿ Lengths of Connecting Subsystems
Attach to
Overhead
Anchor!
Swing Falls
Increase
Fall Arrest
Distance
13. LIMITATIONS CONTINUED:
Ÿ Swing Falls: Swing falls occur when the anchorage point is not directly above the point where a fall occurs. The force of striking
an object in a swing fall may cause serious injury or death. Minimize the risk of a swing fall by working as close to the anchorage
point as possible. Do not permit a swing fall if injury could occur. Swing fall will significantly increase the clearance required
when a self retracting lifeline or other variable length connecting system is used.
Ÿ Potential Environmental Hazards: Use of fall protection equipment in areas with environmental hazards may require additional
precautions to prevent injury to the user or damage to the equipment.Hazards may include but are not limited to: chemicals,
corrosive environments, high voltage power lines, gases, moving machinery, and sharp edges.
14. APPLICABLE STANDARDS: Refer to potential applicable standards. Standards might include OSHA regulations depending on the type
of work, and also might include state regulations where applicable. Consult regulatory agencies for more information on personal fall
arrest system and associated components. This product is designed to comply with OSHA and ANSI Z359.14 standards when used
properly, and in accordance with manufacturer's instructions.
15. SYSTEM REQUIREMENTS:
Ÿ Compatibility of Components: FRONTLINE Fall Protection
equipment is designed to be used with FRONTLINE approved
components. Please contact FRONTLINE if you have a question
regarding compatibility. Making substitutions without approval
from FRONTLINE Protection may lead to injuries and or death by
compromising the safety and reliability of any component or that
of the complete system. A qualified and competent person can
make a determination on compatibility of equipment from
different manufacturers. If in doubt, please contact FRONTLINE Fall
Protection for clarification.
Ÿ Compatibility of Connectors: Connectors (D-rings, hooks,
carabiners) must be capable of supporting at least 5,000 lbs.
(22kN). Do not use equipment that is not compatible. Non-
compatible connectors may unintentionally disengage. Self
locking snap hooks and Karabiners are required by ANSI and
OSHA. Connectors must be compatible in size, shape, and
strength.
Ÿ Making Connections: Only use self-locking snap hooks and
carabiners with any FRONTLINE Fall Protection equipment. Do not use equipment that is not compatible. If you have any questions on
compatibility, plese contact FRONTLINE.
WARNING:
Large throat opening snap hooks should not be connected to standard size D-rings or similar objects which will result in a
load on the gate if the hook or D-ring twists or rotates. Large throat snap hooks are designed for use on fixed structural
elements such as rebar or cross members that are not shaped in a way that can capture the gate of the hook.
Max 7.5 Feet
Fall clearance
Total Fall Distance
(Free Fall +
Deceleration)
8
To Next Page
Loading...
