MAINTENANCE, CLEANING AND STORAGE
Cleaning periodically will prolong the life and proper functionalityof the product. The frequency
of cleaning should be determined by inspection and by severity of the environment. Clean with
compressed air and/or a sti brush using plain water or a mild soap and water solution. Do not use
any corrosive chemicals that could damage the product. Wipe all surfaces with a clean, dry cloth
and hang to dry, or use compressed air. When not in use, store anchorage connectors in a cool, dry,
clean environment, out of direct sunlight and free of corrosive or other degrading elements.
Inspection:
Ocial periodic inspection must be made at least annually. The inspection must be
performed by a qualied person other than the intended user. If severe weather or conditions
exist then inspections must be carried out more frequently. All inspection results must be
logged in the space provided above. (It is recommended that the anchor device is marked
with the date of the next or last inspection.)
1. Make sure all labeling is axed to the unit.
2. Inspect anchoring system for signs of damage or wear.
3. Inspect rollers ride ush with mounting surface and roll smothly.
4. Make sure the unit can adjust and lock properly on to beam ange.
5. Record inspection results in the space provide above.
*If any damage that could aect the strength or operation or unsafe conditions are
found, proper disposal is required. The anchorage connector must be rendered
unusable and then properly discarded.
DATE OF MANUFACTURE:
INSPECTION AND MAINTENANCE LOG
Part Number Comments Inspector Name
MODEL NUMBER:
Date
To Next Page
Loading...
Need help?
General
