FAST INSTALLATION
4
3.1 Install Front Wheel
1. loosen the spacer and nut on the bearing
using a 14mm and 19mm wrench.
2. Place the spacer on the inner side of the
front fork, and thread the bearing through
the spacer and the tire.
3. Place the other spacer on the opposite side of the tire, and thread the
bearing through it.
4. Thread the nut onto the end and secure it using a 14mm and 19mm
wrench.
3.2 Install Front Fender
1. Loosen the screws at the mounting position
of the front fender on the front fork.
2. Place the front fender onto the front fork.
Fasten the front fender in place with screws
and tighten them using Hex Screwdrivers.
3. Check the clearance between the front fender and the front wheel,
ensuring sufficient space to prevent any rubbing or contact between
the tire and the fender.
To Next Page
Loading...
