ADJUSTMENT
7.1 Carburetor Adjustment
7.2 Brake Adjustment
11
Never start the engine without the complete clutch cover
assembled! Otherwise, the clutch can come loose and cause
injuries.
When the engine is tested at the factory, the Carburetor is basically
adjusted. Further adjustment may be required occasionally,
depending on climate and altitude.
When the engine is idling, under no circumstance should your
motorcycle be moving.
If the motorcycle continues to move after idle speed adjustment,
contact the service center.
The Brakes on the motorcycle should come fully adjusted from the
factory. However, it may be necessary to change the brake from time
to time.
1. With one hand, depress the brake caliper using your thumb and
forefinger.
2. With the other hand, adjust the tension screw on the brake line.
a. Turn the tension screw clockwise to loosen the brake.
b. Turn the tension screw counterclockwise to tighten the brake.
Squeaky Brakes
The brakes may squeak before they are broken in. This is normal and
will not affect the function or performance of the brakes. With
continued use, the squeak should go away.
To Next Page
Loading...
