PREPARING FOR USE
4.3 Starting the Dirt Bike
1. Before starting, make sure to fill the fuel tank with the
recommended fuel grade, maintaining a minimum fuel level of at
least two-thirds of the tank's total capacity.
2. Depress the vent valve to release any residual air from the fuel line
until no air bubbles are visible in the fuel line. Ensure the valve is
filled with fuel, then depress it 3-5 times. This valve is typically
located below the carburetor.
3. Confirm that the kill switch is in the "ON" position.
4. Shift the choke lever to the "OFF" position.
5. Slowly pull the pull start to its maximum length about three times
to establish the proper pull length. Then, pull the pull start rapidly
until the engine starts. Wait for 10-15 seconds, then return the air
control lever to the "ON" position. If the engine stalls, repeat steps 4-5
until the engine starts.
6. Once the engine starts, allow it to idle for 2-3 minutes to ensure it
reaches the optimal operating temperature.
8
Important Note
a. After prolonged operation under heavy load, the engine may shut
down due to overheating. In such cases, park the vehicle and allow
it to cool for at least 15 minutes before attempting to restart. When
restarting, begin from step 2.
b. When rapidly pulling the starter handle, be sure not to exceed the
maximum pull length to prevent damage.
c. During the vehicle startup process, avoid maintaining continuous
maximum throttle, as it may hinder the starting process.
To Next Page
Loading...
