CONTROLS
6.1 Braking
6.2 Braking System
6.3 Stopping
10
The motorcycle uses a disc/caliper braking system activated by a hand
brake lever on the left and right side of the handlebar.
Squeezing the hand brake lever with your left hand activates the rear
brake. Make sure to release the HAND THROTTLE GRIP when
engaging the brakes.
Practice braking on a smooth, dry surface to get used to the feel of the
braking system. Braking distance is affected by wet conditions and
loose and uneven riding surfaces.
1. To brake, release the hand throttle and depress the hand brake
levers (on the left and right side of the handlebars).
2. Gradually decrease the engine speed to idle and turn off the kill
switch on the handlebar. This will turn the engine OFF.
Stop the throttle handle or pull down the switch in an emergency. But
in normal status, please operate as follows:
1. Reduce the gasoline engine to the lowest speed and run for 3-5
minutes.
2. Pull down the stop switch and stop the engine.
To Next Page
Loading...
