FAST INSTALLATION
5
3.3 Install Handlebar
1. loosen the screws on the handlebar presses, then separate the
upper handlebar press from the lower handlebar press.
2. Place the lower pressure block beneath the handlebar, then
insert the screws of the upper handlebar press into the screw
holes of the lower handlebar press.
3. Insert the entire handlebar press into the screw holes above the
front fork.
4. Secure the handlebar press in place using a nut.
5. Tighten the handlebar presses using a 10mm and 13mm wrench.
6. Adjust the handlebar's angle to securely fasten the handlebar
press in place.
To Next Page
Loading...
