Frymaster Performance MJ40 - Qualified Personnel Requirements; Definitions

1-4
40 Model Family
Model
Built-In
Filtration
Controls
(Note: Millivolt controls require no external power.)
MJ*40†/GF16FR/A
GF14
No Millivolt. Thermostat knob inside door.
FMJ*40 or
FPP*35
Yes
Millivolt. Thermostat knob inside door. (Requires external power supply for
filter.)
* Insert the number of fryers in the battery (e.g., a MJ140 has one fryer, a MJ240 or an FMJ240 has two fryers;
an FMJ240S has two fryers and one holding station, an FMJ240 has two fryers and no holding station. There
is no FMJ140).
† Available with pilot ignition only.
50 Model Family
Model
Built-In
Filtration
Controls
(Note: Millivolt controls require no external power.)
MJ*50†
No Millivolt. Thermostat knob inside door.
MJ*50E
No Electric. Digital or CM III.5 Controller.
MJ*50EC
No Electric. CM III.5 Computer.
MJ*50EBLC
No Electric. CM III Computer.
FMJ*50
Yes
Millivolt. Thermostat knob behind door. (Requires external power supply for
filter.)
FMJ*50EC
Yes Electric. CM III.5 Computer.
FMJ*50EBLC
Yes Electric. CM III.5 Computer.
FMJ*50EBLM
Yes
Electric. Thermostat knob on control panel with push-button basket lift
control plus ON/OFF and melt cycle switches.
FMJ*50EM
Yes
Electric. Thermostat knob on control panel with ON/OFF and melt cycle
switches.
* Insert the number of fryers in the battery (e.g., a MJ150 has one fryer, a MJ250 or an FMJ250 has two fryers;
an FMJ250S has two fryers and one holding station. There is no FMJ150).
† Available with pilot ignition only.
1.6 Installation, Operating, and Service Personnel
Operating information for Frymaster equipment has been prepared for use by qualified and/or
authorized personnel only, as defined in Section 1.7. All installation and service on Frymaster
equipment must be performed by qualified, certified, licensed, and/or authorized
installation or service personnel, as defined in Section 1.7.
1.7 Definitions
QUALIFIED AND/OR AUTHORIZED OPERATING PERSONNEL
Qualified/authorized operating personnel are those who have carefully read the information in
this manual and have familiarized themselves with the equipment functions, or who have had
previous experience with the operation of the equipment covered in this manual.