FS S5800 Series - Configuration System Troubleshooting; No Information on the Terminal

Data Center, Enterprise & ISP Network Solutions
07
4.5 No Information on the Terminal:
4.4 Configuration SystemTroubleshooting:
After power-on, if no display information on configuration terminal appears, please check if:
The power is normal.
The cable of configuration port (Console) is properly connected. If no problems have been found
after the above checks, it is possible that configuration cable is faulty or the parameter setting of
terminal (such as super terminal) are incorrect, please check accordingly.
Troubleshooting for the terminal displaying hashes:
If the configuration terminal displays hashes, it is probable that the parameter setting of terminal
(such as super terminal) are incorrect Please confirm the parameter setting of terminal (such as
super terminal): baud rate: 115200, data bit: 8, parity: no, stop bit: 1, flow control: NA, selecting
terminal emulation: VT100.
After the switch is powered on, if system is normal, the startup information will be displayed
on the configuration terminal; If the configuration system is faulty, the configuration terminal
may display no information or hashes.