FTI LB-10 - General Specifications; Figure 1.3-1 Little Brute Puller Unit Parts

Fatigue Technology Inc. 401 Andover Park East Seattle, WA • USA 98188-7605 Tel: (206)246-2010 Fax: (206)244-9886
2 57429 – Rev L
1.3 GENERAL SPECIFICATIONS
The LB-20 Puller Unit is the preferred model by most customers since material stack-ups rarely exceed 2 inches
(50.8 mm) in the applicable diameter range.
Nosecap Selection: The Little Brute is compatible with both the standard nosecap and the flush nosecap. See
FTI’s comprehensive Tooling Catalog for more information.
Mandrel Selection: The Little Brute is directly compatible with standard Type 1, 7/16-20 threaded mandrels.
The LB may also be adapted to tang or pintail mandrels using LB-CA and LB-PC chuck assemblies,
respectively. See FTI’s comprehensive Tooling Catalog for more information.
Figures 1.3-1 and 1.3-2 show the parts and specifications of the Little Brute Puller Unit.
Figure 1.3-1
Little Brute Puller Unit Parts
Housing
Barrel
Handle
Trigger
Hose
Assemblies
Threaded
Adapter
End Cap
Figure 1.3-1
Little Brute Puller Unit Parts