Fuji Electric ALPHA7 Series - Product Specifications; Detailed Specifications

3. Product Specifications
The WSU-ST1 product specifications are as follows.
3.1 Specifications
Item
Details
Interface power supply
24 VDC ±10%
Usage
environment
Ambient temperature
During operation: -10 to 55 °C, During storage, transport: -20 to 80 °C
Ambient humidity
5 to 90% (there should be no freezing or condensation)
Atmosphere
∙ There should be no dust, direct sunlight, corrosive gas, flammable gas,
oil mist, steam, or water droplets. (Pollution level 2 (IEC60664-1))
(Note)
∙ There should be very little salt content. (0.01 mg/cm
2
/year or less)
∙ There should be no condensation as a result of sudden temperature changes.
(Note) Do not install in environments in which the cooling fan may become
clogged with dust containing waste thread or dampness, etc. If using the
product in such an environment, install inside a control panel into which
waste thread, etc. cannot enter.
Altitude
1,000 m or lower
Atmospheric pressure
During operation : 90 to 106kPa, During storage: 90 to 106kPa:
During transport : 90 to 106kPa
Vibrations
3 mm: less than 2 to 9Hz, 9.8 m/s
2
: less than 9 to 20Hz
2m/s
2
: less than 20 to 55Hz. 1 m/s
2
: less than 55 to 200Hz
Other
[UL Standard, Low Voltage Directive]
Ensure that the installation conditions described in the "ALPHA7 Series" servo
amplifier instruction manual and user's manual are satisfied.
[EMC Directive]
Ensure that the installation conditions described in the "ALPHA7 Series" servo
amplifier instruction manual and user's manual are satisfied.
Compatibility with the EMC Directive may vary depending on conditions such as
the actual product configuration and wiring, and therefore compatibility should
be checked on the customer's machine at which EMC countermeasures have
been applied.
Safety function
Safe Stop 1 (SS1)
Safe-Limited Speed (SLS)
Safe Brake Control (SBC)
Safe Speed Monitor (SSM)
Compatible
standards
EN ISO 13849-1 : 2015 Cat. 3 / PL-d
IEC / EN 61508 : SIL2
IEC / EN 61800-5-2 : 2016 SIL2
IEC / EN 62061 : 2015 SILCL2
IEC / EN 61000-6-7 : 2014
Safety
functions
PFH
(probability of dangerous failure per hour)
PFH ≤ 1.5 x 10
-7
MTTFd
12 years or longer
Deterministic capability
SC2
SFF (Safe Failure Fraction)
SFF: 90% or higher, Type B
Proof test (Life time)
10 years
Stop category
0, 1 ( IEC / EN 60204-1 )
Response time / Fault reaction time
80 ms or less