Pump Control Quick Guide
3
Thank you for purchasing
,
Fuji Electric’s inverter for pump and fan applications. This guide
is structured as follows:
CHAPTER 0: Introduction to pressure control systems
9 types of pump control
5
CHAPTER 1: Single pump control
Electrical diagram
6
Sleep Function 7
Wake-up Function 7
Common parameters for pump control
9
Common parameters description
10
CHAPTER 2: Mono-regulated pump control with 1 regulated pump + 1,2,3 or 4 auxiliary pumps
Mono-regulated pump (mono-joker) control with 1 regulated pump + 1 auxiliary pump electrical diagram
12
Mono-regulated pump (mono-joker) control with 1 regulated pump + 2 auxiliary pumps electrical diagram
13
Mono-regulated pump (mono-joker) control with 1 regulated pump + 3 auxiliary pumps electrical diagram
14
Mono-regulated pump (mono-joker) control with 1 regulated pump + 4 auxiliary pumps electrical diagram
15
Connecting auxiliary pumps 17
Disconnecting auxiliary pumps 18
Common Parameters for pump control 19
Specific parameters 20
Specific parameters description 20
CHAPTER 3: Mono-regulated pump control with 1 regulated pump + 4 auxiliary pumps + 1 additional pump
Electrical diagram
22
Common parameters for pump control 24
Specific Parameters 25
Specific parameters description 25
CHAPTER 4: Multi-regulated pump (multi-joker) control with 2/3 regulated pumps
Multi-regulated pump (Multi-joker) control with 2 regulated pumps electrical diagram
27
Multi-regulated pump (Multi-joker) control with 3 regulated pumps electrical diagram
28
Connecting a regulated pump to commercial power supply 30
Disconnecting a regulated pump from commercial power supply 30
Common parameters for pump control 32
Specific parameters 33
Specific parameters description 33
Specific parameters description having optional card relay installed 34
CHAPTER 5: Multi-regulated pump (Multi-joker) control with 3 regulated pumps + 1 additional pump
Electrical diagram
35
Common parameters for pump control 37
Specific Parameters 38
Specific parameters description 39
CHAPTER 6: Various Functions
Dry well function
40
Overpressure alarm 41
User units set-up 42
Start-up and switching motors sequence 42
Contactor delay time 43
Stopping mode selection when removing “RUN” signal (FWD or REV goes off) 43
Multiple PID set points selection 43
Dead band 44
Dew condensation prevention function 44
Integral PID component hold 44
Enable / disable pumps by means of external selectors
46
CHAPTER 7: Function codes list. Digital and analog I/O functions
47
CHAPTER 8: Using TP-E1 keypad (basic keypad)
53
CHAPTER 9: Optional relay card OPC-F1-RY
54
To Next Page
Loading...
