Fuji Electric FRENIC-Multi - Contents

viii
CONTENTS
Part 1 General Information
Chapter 1 INTRODUCTION TO FRENIC-Multi
1.1 Features..................................................................................................................................................... 1-1
1.2 Control System ....................................................................................................................................... 1-11
1.3 Recommended Configuration.................................................................................................................1-13
Chapter 2 PARTS NAMES AND FUNCTIONS
2.1 External View and Allocation of Terminal Blocks.................................................................................... 2-1
2.2 LED Monitor, Keys and LED Indicators on the Keypad..........................................................................2-2
Chapter 3 OPERATION USING THE KEYPAD
3.1 Overview of Operation Modes ................................................................................................................. 3-1
3.2 Running Mode..........................................................................................................................................3-3
3.2.1 Monitoring the running status............................................................................................................. 3-3
3.2.2 Setting up frequency and PID process commands..............................................................................3-4
3.2.3 Running/stopping the motor................................................................................................................ 3-9
3.2.4 Jogging Operation...............................................................................................................................3-9
3.3 Programming Mode................................................................................................................................3-10
3.3.1 Setting up basic function codes quickly -- Menu #0 "Quick Setup" --..............................................3-12
3.3.2 Setting up function codes -- Menu #1 "Data Setting" --...................................................................3-16
3.3.3 Checking changed function codes -- Menu #2 "Data Checking" -- ..................................................3-17
3.3.4 Monitoring the running status -- Menu #3 "Drive Monitoring" -- ................................................... 3-18
3.3.5 Checking I/O signal status -- Menu #4 "I/O Checking" -- ...............................................................3-21
3.3.6 Reading maintenance information -- Menu #5 "Maintenance Information" -- ................................3-26
3.3.7 Reading alarm information -- Menu #6 "Alarm Information" --...................................................... 3-29
3.4 Alarm Mode............................................................................................................................................3-32
3.4.1 Releasing the alarm and switching to Running mode ....................................................................... 3-32
3.4.2 Displaying the alarm history............................................................................................................. 3-32
3.4.3 Displaying the status of inverter at the time of alarm .......................................................................3-32
3.4.4 Switching to Programming mode...................................................................................................... 3-32
Part 2 Driving the Motor
Chapter 4 BLOCK DIAGRAMS FOR CONTROL LOGIC
4.1 Symbols Used in Block Diagrams and their Meanings ............................................................................4-1
4.2 Drive Frequency Command Block ...........................................................................................................4-2
4.3 Drive Command Block............................................................................................................................. 4-6
4.4 Control Block............................................................................................................................................4-8
4.5 PID Process Control Block.....................................................................................................................4-12
4.6 PID Dancer Control Block...................................................................................................................... 4-16
4.7 FM Output Selector ................................................................................................................................4-19