8-2
8.1.2 Three-phase 400 V series
*1 Fuji 4-pole standard motors
V output voltage.
y voltage.
*2 The rated capacity is for 440
*3 Output voltages cannot exceed the power suppl
(5.2.3))3-61800 IEC to (Refer67
(V)voltage average phase-3
(V)eMin.volt-(V)eMax.voltag
= (%)unbalancevoltageInterphase
*4
ag
×
If this value is 2 to 3 %, use an AC reactor (ACR).
*5 for applicable motor rating).
ff (F 05 =0). (Varies according to the efficiency
ote , C, E, or J depending on the shipping destination. Note that
Tested under the standard load condition (85% load
*6 Calculated under Fuji-specified conditions.
r (option). *7 Indicates the value when using a DC reacto
*8 Average braking torque obtained with the AVR control o
of the motor.)
*9 Average braking torque obtained by use of an external braking resistor (standard type available as
option).
*10 To make FRENIC-Mini compliant with category TYPE1 of the UL Standard (or NEMA1), an optional
NEMA1 kit is required. Note that the TYPE1-compliant FRENIC-Mini should be used in the ambient
temperature range from -10 to +40°C.
: A box () in the above table replaces AN
the FRN4.0C1S-4 can be followed by E only.
To Next Page
Loading...
Need help?
General
