i
Preface
Thank you for purchasing our FRENIC-Mini series of inverters.
This product is designed to drive a three-phase induction motor. Read through this instruction
manual and be familiar with proper handling and operation of this product.
Improper handling might result in incorrect operation, a short life, or even a failure of this product as
well as the motor.
Have this manual delivered to the end user of this product. Keep this manual in a safe place until this
product is discarded.
Listed below are the other materials related to the use of the FRENIC-Mini. Read them in conjunction
with this manual as necessary.
• FRENIC-Mini User's Manual (MEH446)
• RS485 Communications User's Manual (MEH448)
• Catalog (MEH441/MEH451)
• Application Guide (MEH449)
• RS485 Communications Card Installation Manual INR-SI47-0773
• Rail Mounting Base Installation Manual INR-SI47-0774
• Mounting Adapter Installation Manual INR-SI47-0775
• PC Loader Operation Manual INR-SI47-0801-E
• Remote Keypad Instruction Manual INR-SI47-0843-E
• Built-in Braking Resistor Installation Manual INR-SI47-0838
The materials are subject to change without notice. Be sure to obtain the latest editions for use.
Japanese Guideline for Suppressing Harmonics in Home Electric and
General-purpose Appliances
Fuji three-phase, 200 V series inverters of 3.7 (4.0) kW or less (FRENIC-Mini series) are the
products specified in the "Japanese Guideline for Suppressing Harmonics in Home Electric and
General-purpose Appliances" (established in September 1994 and revised in October 1999),
published by the Ministry of International Trade and Industry (currently the Ministry of Economy,
Trade and Industry (METI)). The Japan Electrical Manufacturers' Association (JEMA) has
established a standard of regulation levels based on this guideline. To meet this standard, a reactor
(for harmonic suppression) must be connected to an inverter. It is recommended that you use one of
the DC reactors listed in this manual. If you choose to prepare a reactor other than the ones listed,
however, it is suggested that you consult your Fuji Electric representative for the specifications.
Japanese Guideline for Suppressing Harmonics by Customers Receiving
High Voltage or Special High Voltage
Refer to the FRENIC-Mini User's Manual (MEH446), Appendix C for details on this guideline.
To Next Page
Loading...
Need help?
General
