Fuji Electric POD UG221H-SR4 - Check Errors

7
1. Error Message 7-3
Error Correction
2. Check
3. Warning
An error may be displayed on the Main Menu screen during data transfer.
This is a warning message.
For the warning details and solutions, refer to the User’s Manual <Function> (FEH376) and correct
screen data.
Error Message Contents Solution
Screen No. Error
There is no setting for the
received screen.
At the start of communications, the Simple POD regards the
value in the read area “n + 2” as the screen number.
Check that the value in the read area “n + 2” is an existing
screen number on the PLC.
Data has some error.
Error : XX (XX : XXX)
There is an error in the
created screen data.
“Error : XX (XX : XXX)” indicates the edited screen and the
contents of the error.
For the error details and solutions, refer to the User’s Manual
<Function> (FEH376) and correct screen data.
SYSTEM
F2
F3
F4
F5
F1
POWER
Communication Error
Check I/F driver
Check
SYSTEM
F2
F3
F4
F5
F1
POWER
Screen No. Error
Check
Error Message Contents Solution
Communication Error
Check I/F driver
Although a request to
send is given to the
computer, no answer is
returned within the
specified time.
The I/F driver for simulator is transferred.
If you do not use the simulator, uncheck [Use Simulator]
before transferring data.
SYSTEM
F
2
F
3
F
4
F
5
F1
PO
WE
R
Warning message