Fuji Electric PXZ 5 - Basic Operation and Key Usage

4
2-2 Basic operation
① Condition at power ON
② Selection of parameter
Basic operation of PXZ is shown below. When PXZ4 (1 stage display type) is used, PV/SV is displayed on the one stage
display. In this case, PV/SV display is selected by pressing [SEL]and [PV/SV] keys.
If the unit is not operated for 30 seconds, the display is set to PV/SV display just after power ON.
Operation
Power ON Display at power ON is shown at right.
PXZ4
PXZ5/7/9
Description Display
PV
SV
PV
SV
③ Setting of numerical value
key : Numerical value increases by 1 at each press of key.
It keeps increasing by pressing continuously.
key : Numerical value decreases by 1 at each press of key.
It keeps decreaasing by pressing continuously.
④ Registration of set data
Automatically registered 3 seconds after data is set.
PV
Key type (PXZ)
<Condition at power ON>
SV
P
LoC
No.1 block parameter
< No.1 and No.2 block parameter setting operation >
< Fig. 2-1 Basic operation of PXZ >
SEL
or
SEL
SEL key
3 sec.
SV key
SEL
∧100
∨
P–n1
P
dSP7
No.2 block parameter
SEL
or
∧100
SEL
SEL SELENT ENT
Not
registered
Not
registered
Registered Registered
∧100
I
005.0
5.0
D
SEL
or
or
∧100
∨
∨
∨
∨
∨
∨ ∨
DATA
DATA
PV/SV display
Flicker
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com