Fuji Electric PXZ 9 - Method of Setting Temperature and Parameter

— 12 —
Method of setting temperature and parameter
Operating state (PV/SV indication)
To change temperature setting value (SV)
1) Press key for the position to change value. Light of corresponding position flashes.
2) Press or keys to change value.
3) The value is registered by pressing the
ENT
key.
PV
SV
SV lamp lights
PV
PV lamp lights
･ SV lamp lights, indicating
measurement value(PV)
and setting value(SV).
･ PV lamp lights, indicating
measurement value(PV).
PXZ5, 7, 9 PXZ4
SEL SEL
3 sec. 3 sec.
Cautions in the setting
™ After setting data, the data is automatically registered by pressing the
ENT
key.
™ If the data setting is left as it is for about 30 seconds, the display is automatically returned to the
operating state (PV/SV) display.
™ Where none of optional functions are incorporated into the unit, optional function parameters
will be skipped without appearing on the display.
The 1st block parameters
Operating state display (one-stage display for PXZ4)
By pressing the key once, switching to the 1st block parameters can be made.
Press the key.
Press the and keys.
From here on, repeat the same steps as above
to display the parameters listed at right.
DATA
DATA
Press the key
*Changedvalueisregisterd.
ENT
SEL
SEL
･Thedatainproportional
bandPisdisplayed.
･Bypressingtheand
keysinthisstate,
thedatasettingismade.
SEL
Pressthekey
*Changeofvalueisn'tregisterd.
The operating state (PV/SV) display can be resumed by pressing the key or key in the current state. (For
PXZ4 type, the SV display is resumed.)
Note) “ ”on the upper line is not displayed for PXZ4.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com