Fuji Xerox ApeosPort-IV 3070 Administrator's Manual

Error Code
511
Problem Solving
15
073-210
[Cause] Tray 3 malfunction
[Remedy] Confirm the paper loading condition for the Tray, and then switch off the
machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the error still is not resolved, contact our
Customer Support Center. You can use a tray other than Tray 3.
073-211
[Cause] An error occurred in Tray 3.
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the same message is
displayed again, contact our Customer Support Center.
074-211
[Cause] An error occurred in Tray 4.
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the same message is
displayed again, contact our Customer Support Center.
075-401
[Cause] The life of the paper feed roller of Tray 5 expired.
[Remedy] Replace the Paper Feed Roller Kit (Bypass) with new one.
077-211
[Cause] Detected the installation of a tray of a different type than expected.
[Remedy] Contact our Customer Support Center.
077-213
[Cause] An error occurred in the Duplex Module of the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the error still is not resolved,
contact our Customer Support Center.
077-310
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the same message is
displayed again, contact our Customer Support Center.
077-329
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the same message is
displayed again, contact our Customer Support Center.
077-454
[Cause] Output Tray is full of paper.
[Remedy] Remove all the sheets of paper from Output Tray.
077-455
[Cause] Exit 2 Tray is full of paper.
[Remedy] Remove all the sheets of paper from Exit 2 Tray.
078-210
[Cause] Tray 6 (HCF) malfunction
[Remedy] Contact our Customer Support Center.
078-212
[Cause] An error occurred in Tray 6 (HCF).
[Remedy] Switch off the machine power, and then switch on the machine power.
078-219
[Cause] An error occurred in Tray 6 (HCF).
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the error still is not resolved,
contact our Customer Support Center.
078-500
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the same message is
displayed again, contact our Customer Support Center.
081-799
[Cause] [Fax Transfer from Address Book] is set to [On], but the fax number of
the forwarding destination is not registered in the Address Book.
[Remedy] Register the fax number of the forwarding destination in the Address
Book, or set [Fax Transfer from Address Book] to [Off].
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.

Fuji Xerox ApeosPort-IV 3070 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-IV 3070
Category	Copier
Language	English