Common Service Settings
151
Tools
5
Stored Programming Complete Tone
Set the volume to be sounded when the call of a stored programming registered is
completed.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Line Monitor Volume
When sending a fax, you can relay the sound on the telephone line until the connection is
made through the speakers on the machine. This is convenient for Fax Information Services
without using the telephone receiver.
You can select a volume level from [Soft], [Normal], or [Loud]. To disable the sound, select
[Off].
Ringing Volume
Set the volume to be sounded when the machine receives a fax.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Screen/Button Settings
Set screens and buttons.
Screen Default
Set the screen displayed after powering on the machine or canceling the Power Saver mode.
For more information on the setting procedure, refer to "Customizing the Control Panel" (P.25).
Screen After Auto Clear
Set the screen displayed after Auto Clear.
For more information on the setting procedure, refer to "Setting the Screen After Auto Clear" (P.26).
Auto Display of Login Screen
When the Authentication feature is enabled on the machine, set whether or not to
automatically display the login screen after turning on the machine or canceling the Power
Saver mode.
Custom Buttons 1 to 3
You can assign services such as Copy and Send from Folder to the custom buttons on the
control panel: Custom Button 1 to Custom Button 3.
To leave a feature unassigned, select [(Not Set)].
Note • By factory default, the following services are assigned to each button: [Copy] for the Custom Button
1, [Fax] for the Custom Button 2, and [Review] for the Custom Button 3.
For more information, refer to "Assigning Services to the Custom Buttons" (P.31).
One-touch Buttons
Set the number of address numbers that are assigned to the one touch buttons.
Type 1
Assigns the one touch buttons 1 to 70 to the address numbers 0001 to 0070, and buttons
M01 and M02 to the stored programming jobs 1 and 2.
To Next Page
Loading...
Need help?
General
