16 Appendix
668
Appendix
16
The sample printout is printed.
15 Select [Save].
16 Confirm the result of sample printout.
17 Adjust the alignment again if necessary.
18 Select [Save].
19 Select [Close] until the Services Home screen is displayed.
Note • When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.
C Fold Position Adjustment
1
Select [C Fold - A4] or [C Fold - 8.5x11"], and
then select [Change Settings].
2 Select [Sample Printout].
3 Select the tray in which you loaded paper, and
press the <Start> button.
A sample printout is printed.
4 Select [Close].
5 Check the sample printout, measuring the A and B fold position movement amounts.
6 Enter the values you measured in step 5 in [Values A & B Before Adjustment], and the value
to which to adjust in [Desired Values A & B].
Important • Set value A and value B so that an edge of the paper does not extend beyond a fold position of the
paper. Extending an edge of paper beyond a fold position of the paper may cause a paper jam.
7 Select [Adjust].
8 Select [Sample Printout] again.
To Next Page
Loading...
