Fold Position Adjustment
671
Appendix
16
Important • Set value B so that an edge of the paper does not extend beyond a fold position of the paper.
Extending an edge of paper beyond a fold position of the paper may cause a paper jam.
7 Select [Adjust].
8 Select [Sample Printout] again.
9 Select the tray in which you loaded paper, and press the <Start> button.
The sample printout is printed.
10 Select [Close].
11 Confirm the result of sample printout.
12 Adjust the misalignment again if necessary.
13 Select [Save].
14 Select [Close] until the Services Home screen is displayed.
Note • When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.
To Next Page
Loading...
