Print Overview
319
Printer Environment Settings
7
îš„ NetWare
The machine supports the PServer mode using Netware directory service and bindery
service. The PServer mode enables the machine to function as a printer server, and to
retrieve print jobs in the print queue to output. The printer created for the machine
consumes one user license of the file server.
Note • The machine does not support Remote Printer (RPrinter) mode.
• You can use the machine as a printer in a NDPS environment by using a Novell NDPS Gateway. To
use the machine as a printer in a NDPS environment, you need to have the machine operating in a
NetWare print environment beforehand, or enable LPD in advance and set it as a gateway
destination in a Novell NDPS Gateway setup. Attributes, however, that can be set or obtained by
NDPS are not supported.
z
Supported interfaces
- 1000BASE-T
- 100BASE-TX
- 10BASE-T
Note • 1000BASE-T is not supported for some models. For such models, an optional component is required.
z
Supported frame types
- Ethernet II specification
- IEEE802.3 specification
- IEEE802.3 / IEEE802.2 specification
- IEEE802.3 / IEEE802.2 / SNAP specification
Note • The machine sends out packets of each frame type on the network, and will initialize for the same
frame type as that of the first reply packet received. The frame type can also be fixed. If, however,
there are multiple protocols running on the same network, use Ethernet II specification.
• Some network equipment, such as hubs, may not be compatible with the automatic frame type
detection. If a data link indicator corresponding to the port of the network equipment connected
with the machine is not lit up, change the frame type settings of the machine accordingly with that
of the file server. Use CentreWare Internet Services to change these settings.
For more information on how to set up the machine using NetWare, refer to "Installation When Using NetWare" (P.326).
îš„ SMB
Use SMB to print using Microsoft Networks.
For more information on how to set up the machine using SMB, refer to "Installation When Using Microsoft Network (SMB)"
(P.329).
îš„ IPP
Use IPP to print via the Internet.
For more information on how to set up the machine using IPP, refer to "Installation When Using Internet Printing Protocol
(IPP)" (P.331).
îš„ Port 9100
Use Port9100 when the machine uses Port 9100.
For more information on how to set up the machine using Port 9100, refer to "Installation When Using TCP/IP (LPD/Port
9100)" (P.323).
îš„ EtherTalk
Use EtherTalk when you print from a Macintosh computer. The Adobe PostScript 3 Kit
(optional) is required.
Note • The Adobe PostScript 3 Kit (optional) is required.
For more information on how to set up the machine using EtherTalk, refer to "Installation When Using EtherTalk" (P.333).
To Next Page
Loading...
Need help?
General
