11 Using the Internet Fax Service
376
Using the Internet Fax Service
11
Installation Procedures
This section describes the configuration procedures to use the Internet Fax feature on the
machine.
The following shows the reference section for each procedure.
Step 1 Enabling Port and Setting up TCP/IP......................................................................................................................... 376
Step 2 Configuring E-mail Environment................................................................................................................................. 377
Step 3 Testing the Internet Fax ............................................................................................................................................... 378
Step 1 Enabling Port and Setting up TCP/IP
To use the Internet Fax feature on the machine, enable the ports for the E-mail feature, and
set the IP address. The following shows the configuration procedures on the machine.
Note • You can configure the settings using CentreWare Internet Services.
For information on how to use CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare
Internet Services" (P.313).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable ports to use for the E-mail feature.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [Receive E-mail], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close].
7) Select [Enabled] for [Send E-mail - Port Status] on the [Send E-mail] screen as described
above.
8) Select [Close] repeatedly until the [Tools] screen is displayed.
3 Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
address. If an IP address cannot be obtained automatically, or if manual configuration is
preferred, confirm the settings of an IP address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.201).
4 Select [Close] repeatedly until the [Tools] screen is displayed.
To Next Page
Loading...
Need help?
General
